Next fold over both ends of the cable by about 1 and 1/2 inch with a mark centered in each fold without changing the size of the loop. Place a mark on both legs of the cable far from either end and at some point where it overlaps. This ensures that the cable is hidden from view when it is hung. Size the loop by placing the bottom of the loop around the mounting while keeping the loop from exceeding the top of the monitor. Overlap the ends of the cable making a loop. Next place a pair of washers and a machine screw in the top two mounting holes of the monitor. For practice on what it will feel like to drill into a stud, try drilling into a piece of wood that is out of sight, say the bottom shelf of a set of shelves or a bottom drawer of a set of drawers. This distance is often 16 inches, however it can be either 12 inches in older homes or 24 inches in modern homes. To find another stud closer to where you want to place the monitor, measure a set distance to either side of the drill hole where you found the stud.
You can check by gently backing the drill bit out and checking the tip for any signs of wood. Chances are good that you've found a stud. Continue the pattern until you drill through the drywall and encounter resistance and need to force the drill forward. If this is the case drill about 3/4th on an inch to either side of the first hole. If there is nothing behind the drywall, the drill will suddenly move forward with little resistance. Using the smallest drill bit, drill straight into the wall. From nails and screws to drill bits, damaging wires behind your wall will at the least cost you to fix and at worse could burn down your dwelling. NOTE: Care must be taken when placing anything that can conduct electricity into a wall. Ideally the drilling should be done just above the base board to both avoid wires behind the wall and to hide the holes where no one will look. The outlet was used as a starting point for the drilling. In this case a stud was found behind the wall by drilling bellow an electrical outlet.
#Raid monitor wall imune software#
The software application supports SMTP connection encryption via SSL.Of utmost importance is to have a sturdy fixture to hang the monitor from.
#Raid monitor wall imune password#
To fix this issue, it's possible to launch multiple instances of the application and configure settings for multiple monitored mirrors.Īdditional options focus on specifying an alternate target to the mirror on non-EN systems (-m ), setting the diskpart OK status for healthy mirrors on non-EN systems (-o ), and entering a username and password for SMTH authentication if required (-u and -w ). The app is not capable of monitoring the status of multiple mirrors at once. It's possible to specify the sender address (-f ), SMTP destination host (-h ) and port (-p,, default is 25), together with the receiver address (-t ) and drive letter of the mirror whose status has to be checked (-l ). However, it can be forced to send messages even when it's healthy (-a). īy default, WinRaidMonitor sends emails only when the disk becomes unhealthy. The complete syntax is WinRaidMonitor -f -h -l -t. The tool can only be controlled from the command-line interface since it doesn't have a GUI. It's capable of sending notifications via email when the disk becomes unhealthy. WinRaidMonitor is a Java-based application designed to monitor the health of RAID (Redundant Array of Inexpensive Disks).
0 kommentar(er)
